LQS FLEX GP – Two-component, elastic, cementitious waterproofing and protective mortar

ADVANTAGES

• Easy to mix and apply, with a slurry-like consistency
• Highly cost-effective
• Good adhesion to sound substrates
• Waterproof — enhances durability and service life of structures
• Non-toxic, non-corrosive, and flexible
• Can be applied by brush or spray

APPLICATIONS

LQS Flex GP is used for internal and external waterproofing in construction, repair, and protection against frost and de-icing agents. Typical application areas include:

• Drinking water and fire-fighting water tanks
• Basements, terraces, and balconies
• Bridges and retaining walls
• Sealing hairline cracks that have stabilized

TECHNICAL SPECIFICATIONS

INSTRUCTIONS FOR USESurface Preparation:

• Concrete and mortar surfaces must be clean and free from oil, grease, and loose materials.
• Fully saturate absorbent surfaces with clean water before applying the first coat of LQS Flex GP.

Mixing:

• Under normal conditions, mixing both components at the recommended ratio will produce a thick slurry.
• In a clean container, gradually add the powder (Part B) into the liquid (Part A) while mixing with a slow-speed mechanical mixer (max. 500 RPM).
• Mix until homogeneous.

Application:

• Apply the first coat of LQS Flex GP on the saturated surface using a brush, broom, or trowel.
• Allow the product to harden for 1–2 hours at temperatures above 27°C before applying the second coat.
• On floors, to avoid damaging the first coat, it’s best to apply the second coat after about 2 hours.
• If applying the second coat after 8 hours or more, re-wet the first layer before re-coating.

Curing:

• Like all cement-based materials, LQS Flex GP must be protected from direct sunlight, strong winds, and frost for 3 to 5 days after application to ensure proper hydration and minimize cracking.
• Use plastic sheets or other approved curing methods.

Tool Cleaning:

• Clean all tools and equipment immediately with clean water after use.
• Cured material can only be removed mechanically.

Additional Notes:

• Wait at least 3 days after application before exposing the waterproofed surface to water immersion.
• Always use LQS Latex slurry bonding agent to avoid delamination when applying protective/finishing mortar over the waterproofing layer.
• Always perform a trial application before large-scale use.

SAFETY INFORMATION

• Protective Equipment: Wear appropriate protective clothing, gloves, and goggles during use
• Ecology: Do not dispose of into water bodies or soil
• Transport: Non-hazardous
• Reference: Always consult the Material Safety Data Sheet (MSDS) and related safety documentation before use